Juicy Smash Burger (Print)

Crispy-edged, juicy beef patties with classic toppings on toasted buns

# What You’ll Need:

→ Beef

01 - 1 lb ground beef (80/20 blend recommended)

→ Seasonings

02 - 1 tsp kosher salt
03 - ½ tsp freshly ground black pepper

→ Buns & Toppings

04 - 4 burger buns
05 - 4 slices American cheese (or cheddar)
06 - 1 small red onion, thinly sliced
07 - 1 large tomato, sliced
08 - 4 lettuce leaves
09 - 4 tbsp burger sauce (mayonnaise, ketchup, mustard blend)
10 - 2 tbsp unsalted butter (for toasting buns)

→ Optional Additions

11 - Dill pickle slices

# How To Make:

01 - Divide the ground beef into 4 equal portions and loosely roll into balls. Do not pack tightly.
02 - Heat a large cast-iron skillet or griddle over high heat until very hot.
03 - Place the beef balls on the hot skillet. Using a heavy spatula or burger press, smash each ball down firmly until about ½-inch thick.
04 - Season immediately with salt and pepper. Cook without moving for 2–3 minutes until edges are deeply browned and crispy.
05 - Flip burgers, top each patty with a slice of cheese, and cook 1–2 minutes more until cheese melts and burgers are cooked through.
06 - While burgers cook, melt butter in a separate skillet or on the griddle. Toast buns, cut side down, until golden brown.
07 - Spread burger sauce on bottom buns, add lettuce, tomato, and onion. Top with smash patties, pickles if desired, and cover with top bun.
08 - Serve immediately.

# Expert Tips:

01 -
  • The crispy lace edges develop flavor you cannot get from any other cooking method
  • These come together faster than delivery and taste infinitely better
  • The loose meat technique ensures juicy tender burgers every single time
02 -
  • The heavier your spatula the better your smash will be
  • Season immediately after smashing while meat is raw
  • Do not flip until you see that deep brown crust forming
03 -
  • A cast iron skillet holds heat better than anything else for this technique
  • Room temperature meat creates a more even cook
  • Smoking point means the pan is ready to work

Go Back